Acura OBD-II Error Code P1190

Acura OBD-II Major Transmission

Model: OBD-II | Code: P1190

Applicable Systems
ILX TLX RDX MDX NSX

Symptoms

The TCM has detected a manufacturer-specific transmission control fault. The transmission warning light is on. DTC P1190 is stored in the Acura engine control module.

Possible Causes

  • Shift solenoid electrical fault
  • Transmission control module fault
  • Input/turbine speed sensor fault
  • Output speed sensor fault

Troubleshooting Steps

  1. Step 1: Connect an OBD-II scanner and read DTCs to confirm P1190
    DTC P1190 present with freeze frame data
  2. Step 2: Inspect wiring and connectors in the affected circuit for damage, corrosion, or loose pins
    Wiring intact, connectors clean and seated
  3. Step 3: Perform component-level testing per manufacturer service manual
    Component values within spec or component confirmed faulty
  4. Step 4: Repair or replace the faulty component, clear DTC, and verify no return
    DTC cleared and does not return after a road test

How to Reset

Clear the DTC after repair using a diagnostic scanner. The code clears automatically if the fault is not detected for 3 consecutive drive cycles.

Common Replacement Parts

  • varies: Diagnose and replace the confirmed faulty component (Confirm part number via VIN at a Acura dealership)

Frequently Asked Questions

  • Q: What does P1190 mean?

    This manufacturer-specific DTC indicates a transmission system fault. Refer to the vehicle's service manual for the exact diagnostic procedure.

  • Q: Can I drive with P1190?

    Limited driving is possible, but the affected system may not operate correctly. Have the vehicle diagnosed promptly to prevent potential damage.

Related Acura Fault Codes

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: SAE J2012 Acura Manufacturer-Specific DTC

Category: OBD-II