Audi OBD-II Error Code P1125

Audi OBD-II Major Air Flow / MAP

Model: OBD-II | Code: P1125

Applicable Systems
A3 A4 A6 Q5 Q7

Symptoms

The ECM has detected a air flow and manifold pressure fault. The check engine light is illuminated. Vehicle may experience reduced performance, rough idle, or failed emissions test.

Possible Causes

  • Wiring open or shorted to ground
  • Connector corrosion or loose pin
  • Sensor internal failure

Troubleshooting Steps

  1. Step 1: Connect OBD-II scan tool and read all active DTCs
    DTC code and freeze frame data retrieved
  2. Step 2: Inspect wiring harness and connectors for damage or corrosion
    Wiring intact, connectors clean and seated
  3. Step 3: Test sensor or actuator resistance and signal output
    Component output within manufacturer specification
  4. Step 4: Check fuse for the circuit and replace if blown
    Fuse intact or replaced with correct rating
  5. Step 5: Clear DTC with scan tool and road test to verify repair
    No re-occurrence of DTC after test drive

How to Reset

To reset: Clear the DTC with an OBD-II scan tool after repairing the underlying issue. Drive the vehicle through a complete drive cycle to confirm the repair.

Frequently Asked Questions

  • Q: What does P1125 mean on a Audi?

    P1125 is a manufacturer-specific code indicating a air flow and manifold pressure issue. Refer to the Audi service manual for exact component identification.

  • Q: Can I drive with P1125 active?

    Short-term driving is possible, but the underlying issue should be diagnosed promptly to prevent catalytic converter or engine damage.

Related Audi Fault Codes

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: SAE J2012 Manufacturer-Specific DTC, Audi Service Manual

Category: OBD-II