Audi P3007: Audi OBD-II Error Code P3007

Symptoms

The Audi powertrain control module has detected a manufacturer-specific fuel and air metering system fault. The check engine light is on. DTC P3007 is stored.

Possible Causes

Manufacturer-specific fuel and air metering system component failure
Wiring or connector fault in the affected circuit
Control module software calibration issue
Sensor or actuator out of specification

Troubleshooting Steps

Step 1: Connect an OBD-II scanner and read DTCs to confirm P3007
DTC P3007 present with freeze frame data
Step 2: Inspect wiring and connectors in the affected circuit for damage, corrosion, or loose pins
Wiring intact, connectors clean and seated
Step 3: Perform component-level testing per manufacturer service manual
Component values within spec or component confirmed faulty
Step 4: Repair or replace the faulty component, clear DTC, and verify no return
DTC cleared and does not return after a road test

How to Reset

Clear the DTC after repair using a diagnostic scanner. The code clears automatically if the fault is not detected for 3 consecutive drive cycles.

Common Replacement Parts

varies: Replace the confirmed faulty fuel and air metering system component (Confirm part number via VIN at a Audi dealership)

Frequently Asked Questions

Q: What does P3007 mean?
This manufacturer-specific DTC indicates a powertrain - fuel/air system fault. Refer to the vehicle's service manual for the exact diagnostic procedure.
Q: Can I drive with P3007?
Limited driving is possible, but the affected system may not operate correctly. Have the vehicle diagnosed promptly to prevent potential damage.

Audi OBD-II Error Code P3007