Applicable Systems
DVP
AH500
AS300
C2000
MS300
Symptoms
The PLC has detected a hardware fault. The controller stops executing the program and enters FAULT state.
Possible Causes
- Internal CPU or chipset hardware failure
- Power supply instability causing hardware malfunction
Troubleshooting Steps
- Step 1: Power-cycle the PLC and check if the error clears
If 0013 persists after power cycle, hardware is defective - Step 2: Contact Delta technical support for hardware diagnosis
Support confirms hardware failure and recommends replacement
How to Reset
To reset: Power-cycle the PLC. If the error persists, the hardware must be replaced.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Delta DVP PLC Programming Manual, Delta Electronics
Category: PLC & VFD
No comments yet. Be the first to share your experience!