Doosan PUMA TT Series Alarm 2008 (TT Series)

Doosan CNC Moderate Overtravel

Model: PUMA TT Series | Code: 2008

Applicable Systems
DX280 Excavator PUMA MX Series PUMA TT Series

Symptoms

Alarm 2008: GEAR SHIFT LIMIT SWITCH IS ABNORMALLY OPERATING. The CNC system displays this alarm on the operator panel.

Possible Causes

  • Refer to the machine manual for detailed cause analysis
  • Check related sensors, switches, and parameters

Troubleshooting Steps

  1. Step 1: Read alarm 2008 on the CNC display and note the full alarm message
    Alarm code and description displayed for diagnosis
  2. Step 2: Check the machine status and identify any obvious mechanical, electrical, or pneumatic issues
    Visible faults identified or confirmed as intermittent
  3. Step 3: Consult the manufacturer manual for alarm-specific troubleshooting procedures
    Root cause identified per manufacturer guidelines
  4. Step 4: Apply the recommended fix and reset the alarm
    Alarm cleared and machine resumed normal operation

How to Reset

To reset alarm 2008: 1) Address the root cause. 2) Press the RESET key on the CNC panel. 3) If the alarm persists, cycle power to the control. Caution: Repeated alarms without fixing the cause may cause damage.

Frequently Asked Questions

  • Q: What does alarm 2008 mean?

    Alarm 2008 indicates: GEAR SHIFT LIMIT SWITCH IS ABNORMALLY OPERATING. Follow the troubleshooting steps to resolve the issue.

Related Doosan Fault Codes

Source: HelmanCNC.com - https://www.helmancnc.com/doosan-tt-series-alarms/

Category: CNC