Applicable Systems
VMC Series
88HS Control
Fanuc 0i-MC
Symptoms
Alarm 2224: PB TWICE TO RESET, THEN USE JOG OR HANDLE MODE TO MOVE AXIS. The Fadal Fadal PLC (Fanuc 0i-MC) CNC system displays this alarm on the operator panel.
Possible Causes
- Refer to the machine manual for detailed cause analysis
- Check related sensors, switches, and parameters
Troubleshooting Steps
- Step 1: Read alarm 2224 on the CNC display and note the full alarm message
Alarm code and description displayed for diagnosis - Step 2: Check the machine status and identify any obvious mechanical, electrical, or pneumatic issues
Visible faults identified or confirmed as intermittent - Step 3: Consult the manufacturer manual for alarm-specific troubleshooting procedures
Root cause identified per manufacturer guidelines - Step 4: Apply the recommended fix and reset the alarm
Alarm cleared and machine resumed normal operation
How to Reset
To reset alarm 2224: 1) Address the root cause. 2) Press the RESET key on the CNC panel. 3) If the alarm persists, cycle power to the control. Caution: Repeated alarms without fixing the cause may cause damage.
Frequently Asked Questions
- Q: What does alarm 2224 mean?
Alarm 2224 corresponds to: PB TWICE TO RESET, THEN USE JOG OR HANDLE MODE TO MOVE AXIS. This is a Fadal PLC (Fanuc 0i-MC) system alarm that typically requires checking machine state and the manufacturer manual.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: HelmanCNC.com - https://www.helmancnc.com/fadal-plc-alarms-list-plc-messages-fanuc-0i-mc/
Category: CNC
No comments yet. Be the first to share your experience!