Applicable Systems
VMC Series
88HS Control
Fanuc 0i-MC
Symptoms
Alarm Bad-Position-Enc: The position encoder signal is faulty. Check encoder cable, connector, and encoder hardware.. The CNC system displays this alarm on the operator panel.
Possible Causes
- Encoder cable damaged or connector loose
- Encoder hardware failure or signal degradation
- Electromagnetic interference affecting encoder signals
Troubleshooting Steps
- Step 1: Read alarm Bad-Position-Enc on the CNC display and note the full alarm message
Alarm code and description displayed for diagnosis - Step 2: Check the machine status and identify any obvious mechanical, electrical, or pneumatic issues
Visible faults identified or confirmed as intermittent - Step 3: Consult the manufacturer manual for alarm-specific troubleshooting procedures
Root cause identified per manufacturer guidelines - Step 4: Apply the recommended fix and reset the alarm
Alarm cleared and machine resumed normal operation
How to Reset
To reset alarm Bad-Position-Enc: 1) Address the root cause. 2) Press the RESET key on the CNC panel. 3) If the alarm persists, cycle power to the control. Caution: Repeated alarms without fixing the cause may cause damage.
Frequently Asked Questions
- Q: What does alarm Bad-Position-Enc mean?
Alarm Bad-Position-Enc indicates: The position encoder signal is faulty. Check encoder cable, connector, and encoder hardware.. Follow the troubleshooting steps to resolve the issue.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: HelmanCNC.com - https://www.helmancnc.com/fadal-error-messages-emergency-error-codes/
Category: CNC
No comments yet. Be the first to share your experience!