Applicable Systems
Series 0i
Series 16/18/21
Alpha
Beta
Symptoms
The minus sign was placed after an address that cannot accept negative values, or multiple minus signs were used.
Possible Causes
- Program syntax or logic error
- Incorrect parameter or setting
- Operator input mistake
- Corrupted program data
Troubleshooting Steps
- Step 1: Review the CNC alarm display for the specific alarm code and message
Identify the exact alarm code and its description - Step 2: Check the NC program block indicated by the alarm for syntax errors
Locate and correct the programming error - Step 3: Verify all parameters related to the alarm are set correctly
Parameters match the machine specification - Step 4: Clear the alarm by pressing RESET and retry the operation
Alarm clears and operation resumes normally
How to Reset
To reset P/S alarm 006: 1) Correct the program or parameter that caused the alarm. 2) Press the RESET key on the CNC panel. 3) If the alarm persists, power cycle the CNC. 4) For parameter-related alarms, set PWE=0 before resetting. Caution: Always identify and fix the root cause before resetting.
Frequently Asked Questions
- Q: What does 006 mean on Fanuc FANUC 0/0i/30i Series?
The minus sign was placed after an address that cannot accept negative values, or multiple minus signs were used.
- Q: How do I fix 006 on Fanuc?
Follow the troubleshooting steps: Review the CNC alarm display for the specific alarm code and message
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: FANUC CNC System Alarm Manual (doc.eleok.com)
Category: CNC
No comments yet. Be the first to share your experience!