Applicable Systems
TransSteel 2700
Symptoms
An overcurrent condition has been detected in the power module.
Possible Causes
- An overcurrent condition has been detected in the power module.
Troubleshooting Steps
- Step 1: Check for short circuits in the welding circuit
Check if the issue is resolved - Step 2: Reduce the welding current
Check if the issue is resolved - Step 3: Contact Fronius service.
Check if the issue is resolved
How to Reset
Power cycle the welding system and wait for the self-test to complete. If the error persists, contact Fronius service.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Fronius welding technology documentation and xueke.org troubleshooting guide
Category: Welding
No comments yet. Be the first to share your experience!