GSK 980TD/980TDB/980TDC Alarm 330

GSK CNC Moderate GSK Alarm

Model: 980TD/980TDB/980TDC | Code: 330

Applicable Systems
980TDi 928 218 988 GSK 25i

Symptoms

Alarm 330: The axis name of additional axis is not in the setting range or, the axis names of two or more than two additional are the same ones, please set again data parameter#225~#227. The GSK 980TD/980TDB/980TDC CNC system displays this alarm on the operator panel.

Possible Causes

  • Refer to the machine manual for detailed cause analysis
  • Check related sensors, switches, and parameters

Troubleshooting Steps

  1. Step 1: Read alarm 330 on the CNC display and note the full alarm message
    Alarm code and description displayed for diagnosis
  2. Step 2: Check the machine status and identify any obvious mechanical, electrical, or pneumatic issues
    Visible faults identified or confirmed as intermittent
  3. Step 3: Consult the manufacturer manual for alarm-specific troubleshooting procedures
    Root cause identified per manufacturer guidelines
  4. Step 4: Apply the recommended fix and reset the alarm
    Alarm cleared and machine resumed normal operation

How to Reset

To reset alarm 330: 1) Address the root cause. 2) Press the RESET key on the CNC panel. 3) If the alarm persists, cycle power to the control. Caution: Repeated alarms without fixing the cause may cause damage.

Frequently Asked Questions

  • Q: What does alarm 330 mean?

    Alarm 330 corresponds to: The axis name of additional axis is not in the setting range or, the axis names of two or more than two additional are the same ones, please set again data parameter#225~#227. This is a 980TD/980TDB/980TDC system alarm that typically requires checking machine state and the manufacturer manual.

Related GSK Fault Codes

Source: HelmanCNC.com - https://www.helmancnc.com/gsk-cnc-alarm-list-gsk980td-gsk980tdb-gsk980tdc/

Category: CNC