Applicable Systems
Haas CNC Mill (VF/VM Series)
Symptoms
Z axis servo not ready.
Possible Causes
- Z axis servo amplifier not enabled.
- Safety circuit or emergency stop active for Z axis.
Troubleshooting Steps
- Step 1: Check the Z axis servo amplifier enable signal.
Not ready cause identified. - Step 2: Clear the safety circuit or emergency stop.
Z axis servo becomes ready.
How to Reset
Fix the Z axis servo readiness and reset to clear the alarm.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Haas Alarm Codes, Haas Automation
Category: CNC
No comments yet. Be the first to share your experience!