Hyundai ISIS-III Error HYS-E14

Hyundai Elevator Elevator Major Controller

Model: ISIS-III | Code: HYS-E14

Applicable Systems

ISIS-III ISIS-II

Symptoms

Hyundai ISIS-III elevator controller reports fault indicating control system issue requiring diagnostic evaluation of the elevator control system.

Door re-opening signal received during door closing phase without passenger detection
Position self-learning error after controller power restoration
Inverter module overcurrent protection activated during motor acceleration
Safety circuit ground fault detected by insulation monitoring module

Step 1: Access ISIS-III controller diagnostic via maintenance panel
Fault code with timestamp and occurrence count displayed
Step 2: Check door safety edge sensor operation
Safety edge detects obstruction and reopens door
Step 3: Run position self-learning procedure from maintenance menu
Self-learning completes successfully with no errors
Step 4: Measure insulation resistance of safety circuit wiring
Insulation resistance exceeds 1 MOhm to ground

Reset by: 1) Correct the fault condition. 2) Reset controller from maintenance mode. 3) Run test trip. 4) Verify normal operation.

Q: What causes inverter overcurrent during acceleration?
Inverter overcurrent during acceleration is typically caused by excessive load, motor parameter mismatch, or accel/decel time set too short. Verify motor parameters in the drive settings match the nameplate, and check that acceleration time allows for the rated passenger load.