Jaguar OBD-II Error Code P1146

Jaguar OBD-II Major Auxiliary Emission Controls

Model: OBD-II | Code: P1146

Applicable Systems
XE XF F-Pace F-Type I-Pace

Symptoms

The ECM has detected a manufacturer-specific auxiliary emission control fault. The check engine light is on. DTC P1146 is stored in the Jaguar engine control module.

Possible Causes

  • EVAP system leak detected
  • Purge valve stuck open or closed
  • EGR valve position fault
  • Secondary air injection system fault

Troubleshooting Steps

  1. Step 1: Connect an OBD-II scanner and read DTCs to confirm P1146
    DTC P1146 present with freeze frame data
  2. Step 2: Inspect wiring and connectors in the affected circuit for damage, corrosion, or loose pins
    Wiring intact, connectors clean and seated
  3. Step 3: Perform component-level testing per manufacturer service manual
    Component values within spec or component confirmed faulty
  4. Step 4: Repair or replace the faulty component, clear DTC, and verify no return
    DTC cleared and does not return after a road test

How to Reset

Clear the DTC after repair using a diagnostic scanner. The code clears automatically if the fault is not detected for 3 consecutive drive cycles.

Common Replacement Parts

  • varies: Diagnose and replace the confirmed faulty component (Confirm part number via VIN at a Jaguar dealership)

Frequently Asked Questions

  • Q: What does P1146 mean?

    This manufacturer-specific DTC indicates a auxiliary emission controls system fault. Refer to the vehicle's service manual for the exact diagnostic procedure.

  • Q: Can I drive with P1146?

    Limited driving is possible, but the affected system may not operate correctly. Have the vehicle diagnosed promptly to prevent potential damage.

Related Jaguar Fault Codes

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: SAE J2012 Jaguar Manufacturer-Specific DTC

Category: OBD-II