Applicable Systems
9R Tractor
Symptoms
The John Deere equipment displays diagnostic code 1591 on the instrument panel. SCV (Selective Control Valve) Fault has been detected. The equipment may derate, show a warning lamp, or shut down depending on the code severity.
Possible Causes
- SCV (Selective Control Valve) Fault - related sensor or component failure
- Wiring harness or connector fault
- ECU internal fault or software issue
- Fluid level, pressure, or temperature out of range
- Mechanical or electrical component wear
Troubleshooting Steps
- Step 1: Connect John Deere Service ADVISOR diagnostic tool and read all active and stored codes
All codes are retrieved - Step 2: Inspect wiring harnesses and connectors for the affected system
Wiring and connectors are in good condition - Step 3: Use a multimeter to verify sensor voltages, resistances, and actuator circuits per John Deere service manual
Values are within specification - Step 4: Check fluid levels and conditions as applicable to the code
Fluids are at proper levels and in good condition - Step 5: Clear codes and operate equipment to verify the repair
Code does not return and system operates normally
How to Reset
To reset John Deere code 1591: 1) Repair the underlying fault. 2) Use Service ADVISOR to clear codes. 3) Cycle key switch. 4) Verify by operating equipment. Caution: Do not clear without fixing root cause.
Frequently Asked Questions
- Q: What does John Deere code 1591 mean?
Code 1591 indicates: SCV (Selective Control Valve) Fault. This is a John Deere diagnostic code related to Hydraulic.
- Q: How serious is John Deere code 1591?
Severity: Major. Reduce load and seek service.
Source: John Deere Service ADVISOR / Technical Manual - verified via BING International
Category: Heavy Equipment