Applicable Systems
K-Control
Symptoms
Kleemann K-Control elevator controller reports fault indicating control system issue requiring diagnostic evaluation of the elevator control system.
Possible Causes
- Door motor encoder signal loss preventing precise door position control
- Elevator level deviation exceeding 25mm during landing operation
- Safety gear switch signal detected during normal speed operation
- Motor thermal model calculation indicating winding temperature rise
Troubleshooting Steps
- Step 1: Access K-Control diagnostic via maintenance panel
Fault code and description displayed - Step 2: Check door motor encoder cable connection at motor
Encoder cable firmly connected with no bent pins - Step 3: Verify landing level accuracy with measuring tape
Car floor level within 10mm of landing floor - Step 4: Check safety gear switch operation during inspection speed test
Switch remains closed during normal inspection speed operation
How to Reset
Reset by: 1) Correct the fault condition. 2) Reset controller. 3) Run test trip. 4) Verify normal operation.
Common Replacement Parts
- KLM-CTL-001: Kleemann K-Control controller board (Verify model version)
Frequently Asked Questions
- Q: How is landing level calibrated?
Landing level is calibrated by adjusting the position learning data in the K-Control system. The elevator must complete a full travel learning run from bottom to top, stopping at each floor. The controller automatically calculates and stores the leveling parameters.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Kleemann K-Control Technical Manual
Category: Elevator
No comments yet. Be the first to share your experience!