Komatsu Error Code E02 - Engine Speed Sensor Abnormal

Komatsu Heavy Equipment Major Engine

Model: Komatsu Construction Equipment | Code: E02

Applicable Systems
PC200 Excavator

Symptoms

The Komatsu equipment displays error code E02 on the monitor panel. Engine Speed Sensor Abnormal has been detected. The warning lamp illuminates and the equipment may enter derate or shutdown mode depending on severity.

Possible Causes

  • Engine Speed Sensor Abnormal - sensor or component failure
  • Wiring harness or connector fault
  • ECM or controller internal fault
  • Fluid level, pressure, or temperature out of specification
  • Mechanical failure of related component

Troubleshooting Steps

  1. Step 1: Connect Komatsu PC-based diagnostic tool (KOMTRAX) and read all active and historical codes
    All codes are retrieved with timestamps
  2. Step 2: Inspect wiring harness and connectors for the related system
    No damage, corrosion, or loose connections found
  3. Step 3: Use a multimeter to check sensor signals, actuator circuits, and power supplies per Komatsu service manual
    Values are within specification
  4. Step 4: Check fluid levels, pressures, and temperatures as applicable to the code
    Fluids are at proper level and condition
  5. Step 5: Clear codes and operate equipment to verify repair
    Code does not return and system operates normally

How to Reset

To reset Komatsu code E02: 1) Repair the underlying fault. 2) Use the diagnostic tool to clear the code. 3) Cycle the key switch. 4) Operate equipment to verify. Caution: Ensure root cause is resolved before clearing.

Frequently Asked Questions

  • Q: What does Komatsu code E02 mean?

    Code E02 indicates: Engine Speed Sensor Abnormal. This is a Komatsu KOMTRAX diagnostic code related to Engine.

  • Q: How serious is Komatsu code E02?

    Severity: Major. Reduce load and seek service.

Related Komatsu Fault Codes

Source: Komatsu Service Manual / KOMTRAX Diagnostic System - verified via BING International

Category: Heavy Equipment