Applicable Systems
Power Wave
Power MIG
Flextec
MAXX
Vantage
OPTIMARC
Symptoms
Control circuit or motor fault in wire feeder.
Possible Causes
- Control circuit or motor fault in wire feeder.
Troubleshooting Steps
- Step 1: Turn off the machine and disconnect power
Machine is safely powered down - Step 2: Check the input power supply and fuses
Input power is correct and fuses are intact - Step 3: Check the specific component mentioned in the error description
Component is functioning or identified as faulty - Step 4: If the error persists, contact Lincoln Electric Service at 400-820-9755
Professional service arranged
How to Reset
Turn off the machine, wait a few seconds, then turn on again. If the error remains, maintenance is required.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Lincoln Electric China maintenance knowledge base
Category: Welding
No comments yet. Be the first to share your experience!