Mazak MAZATROL Alarm 1034 (IP Address Conflict)

Mazak CNC Moderate Communication

Model: MAZATROL MATRIX / SmoothX | Code: 1034

Applicable Systems
MAZATROL MATRIX MAZATROL Smooth INTEGREX

Symptoms

Alarm 1034: IP Address Conflict. Another device on the network is using the same IP address as the CNC.

Possible Causes

  • Hardware or software issue related to: IP Address Conflict
  • Component failure or communication error
  • Environmental factor (temperature, power, contamination)
  • Configuration or parameter error

Troubleshooting Steps

  1. Step 1: Read alarm 1034 on the Mazak CNC display and note the full message
    Alarm code and description captured for diagnosis
  2. Step 2: Check machine status and identify any visible mechanical, electrical, or pneumatic issues
    Fault condition identified or confirmed as intermittent
  3. Step 3: Consult the Mazak maintenance manual for alarm-specific procedures
    Root cause identified per Mazak guidelines
  4. Step 4: Apply the recommended fix and reset the alarm
    Alarm cleared and machine resumed normal operation

How to Reset

To reset alarm 1034: 1) Address the root cause. 2) Press the RESET key on the CNC panel. 3) If alarm persists, cycle power to the control. Caution: Repeated alarms without fixing the cause may cause damage.

Frequently Asked Questions

  • Q: What does Mazak alarm 1034 mean?

    Alarm 1034 indicates: IP Address Conflict. Another device on the network is using the same IP address as the CNC.

Related Mazak Fault Codes

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: Mazak MAZATROL Matrix/SmoothX Maintenance Manual, helmanCNC.com

Category: CNC