Mazak Alarm Code 614 - MAZATROL Feed Rate Error

Mazak CNC Minor MAZATROL

Model: Mazak MAZATROL | Code: 614

Applicable Systems
MAZATROL MATRIX MAZATROL Smooth INTEGREX

Symptoms

The Mazak CNC control displays alarm code 614. MAZATROL Feed Rate Error has been detected. The machine may stop, enter single block mode, or display a warning message depending on the alarm type and severity.

Possible Causes

  • MAZATROL Feed Rate Error - internal control system error
  • Sensor or actuator fault in the related subsystem
  • Parameter corruption or misconfiguration
  • Wiring harness or connector fault
  • Software or firmware bug

Troubleshooting Steps

  1. Step 1: Record the alarm code and note the machine state when the alarm occurred
    Alarm code and context are documented
  2. Step 2: Check the Mazak diagnostic screen for additional alarm details and related subsystem information
    Additional diagnostic information is retrieved
  3. Step 3: Inspect the related subsystem (PLC, I/O, spindle, servo, safety, etc.) for visible faults or abnormalities
    No visible damage or abnormal conditions found
  4. Step 4: Check parameter settings and compare with backup or known-good values
    Parameters match expected values or discrepancies are identified
  5. Step 5: Power cycle the machine if safe to do so, then clear the alarm and test operation
    Alarm clears and machine operates normally, or alarm returns indicating persistent fault

How to Reset

To reset Mazak alarm 614: 1) Address the root cause per the troubleshooting steps. 2) Press the RESET button on the Mazatrol controller. 3) If alarm persists, power cycle the machine (main power off, wait 30 seconds, power on). 4) After reboot, check if the alarm has cleared. 5) If alarm returns, contact Mazak service. Caution: Do not bypass safety interlocks to reset alarms.

Frequently Asked Questions

  • Q: What does Mazak alarm 614 mean?

    Alarm 614 indicates: MAZATROL Feed Rate Error. This is a Mazak MAZATROL control system alarm related to MAZATROL.

  • Q: How do I clear Mazak alarm 614?

    First resolve the underlying issue, then press RESET. If the alarm persists, power cycle the machine. Persistent alarms require service intervention.

  • Q: Can I continue machining with alarm 614?

    The machine can typically continue operation but the alarm should be addressed soon.

Related Mazak Fault Codes

Source: Mazak MAZATROL Manual / helmancnc.com - verified via BING International

Category: CNC