Applicable Systems
Millermatic
Multimatic
Dimension
XMT
Trailblazer
Syncrowave
Goldstar
Symptoms
Goldstar wire feeder does not feed wire or wire speed is zero.
Possible Causes
- Goldstar wire feeder does not feed wire or wire speed is zero.
Troubleshooting Steps
- Step 1: Check input power supply and verify correct voltage
Input power matches machine rating plate - Step 2: Inspect welding cables, work clamp, and gun connections
All connections are clean, tight, and correct - Step 3: Check wire feed system: drive rolls, guide tubes, liner
Wire feed system is clean and properly aligned - Step 4: Check shielding gas supply and flow rate
Gas flow is adequate and correct type - Step 5: If error persists, contact Miller Electric service at 1-920-735-4505
Professional service arranged
How to Reset
Power cycle the machine. If the error persists, note the error code and contact Miller Electric service.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Miller Electric operator manuals and troubleshooting guides
Category: Welding
No comments yet. Be the first to share your experience!