NUM NUM 1020/1040/1060 Alarm 199

NUM CNC Info Alarm

Model: NUM 1020/1040/1060 | Code: 199

Applicable Systems
1020 1040 1060

Symptoms

Alarm 199: Incorrect variable declaration syntax. The NUM NUM 1020/1040/1060 CNC system displays this alarm on the operator panel.

Possible Causes

  • Refer to the machine manual for detailed cause analysis
  • Check related sensors, switches, and parameters

Troubleshooting Steps

  1. Step 1: Read alarm 199 on the CNC display and note the full alarm message
    Alarm code and description displayed for diagnosis
  2. Step 2: Check the machine status and identify any obvious mechanical, electrical, or pneumatic issues
    Visible faults identified or confirmed as intermittent
  3. Step 3: Consult the manufacturer manual for alarm-specific troubleshooting procedures
    Root cause identified per manufacturer guidelines
  4. Step 4: Apply the recommended fix and reset the alarm
    Alarm cleared and machine resumed normal operation

How to Reset

To reset alarm 199: 1) Address the root cause. 2) Press the RESET key on the CNC panel. 3) If the alarm persists, cycle power to the control. Caution: Repeated alarms without fixing the cause may cause damage.

Frequently Asked Questions

  • Q: What does alarm 199 mean?

    Alarm 199 corresponds to: Incorrect variable declaration syntax. This is a NUM 1020/1040/1060 system alarm that typically requires checking machine state and the manufacturer manual.

Related NUM Fault Codes

Source: HelmanCNC.com - https://www.helmancnc.com/num-cnc-control-errors-list/

Category: CNC