OBD-II Error Code P0104 - Mass Air Flow Circuit Intermittent

OBD-II Standard OBD-II Minor Fuel and Air Metering

Model: SAE J2012 Standard | Code: P0104

Applicable Systems
OBD-II

Symptoms

Check engine light may flash intermittently. The engine may experience occasional hesitation, stumble, or rough idle. The fault is not consistently present.

Possible Causes

  • Intermittent wiring connection at MAF sensor connector
  • MAF sensor internal intermittent failure
  • Wiring harness flexing causing momentary opens
  • Corroded terminals causing intermittent contact
  • Vibration-induced sensor fault

Troubleshooting Steps

  1. Step 1: Connect an OBD-II scan tool and read all stored DTCs and freeze frame data
    All DTCs and freeze frame data are retrieved
  2. Step 2: Inspect the related sensor or actuator wiring for damage, corrosion, or loose connections
    Wiring and connectors are in good condition
  3. Step 3: Use a digital multimeter to check sensor voltage, resistance, and reference signals per manufacturer specifications
    Values are within specified range
  4. Step 4: Perform component-level testing of the suspected sensor or actuator
    Component passes or fails definitively
  5. Step 5: Clear codes and road test to verify repair
    Code does not return and system operates normally

How to Reset

To reset code P0104: 1) Repair the underlying fault. 2) Use an OBD-II scan tool to clear the DTC. 3) Perform a drive cycle to verify the monitor completes. 4) If the code returns, further diagnosis is needed. Caution: Do not clear codes without fixing the root cause.

Frequently Asked Questions

  • Q: What does OBD-II code P0104 mean?

    Code P0104 indicates: Mass Air Flow Circuit Intermittent. This is a SAE J2012 standard diagnostic trouble code related to Fuel and Air Metering.

  • Q: Is code P0104 serious?

    Severity: Minor. The vehicle can typically be driven but should be diagnosed soon.

  • Q: Can I drive with code P0104?

    You can usually drive cautiously but should have it diagnosed and repaired promptly.

  • Q: How do I fix code P0104?

    Diagnose the Fuel and Air Metering system, check wiring and connectors, test the related sensor or actuator, and replace faulty components as needed.

Related OBD-II Standard Fault Codes

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: SAE J2012 Standard - Powertrain Diagnostic Trouble Codes

Category: OBD-II