Applicable Systems
OBD-II
Symptoms
The Key On Engine Running (KOER) self-test could not complete. The check engine light is on and emissions testing may fail.
Possible Causes
- Engine did not reach operating temperature during test
- Throttle position not at idle during test initiation
- Vehicle speed sensor fault during test
- Brake pedal depressed during test
- Power steering pressure switch fault
Troubleshooting Steps
- Step 1: Connect an OBD-II scan tool and read all stored DTCs and freeze frame data
All DTCs and freeze frame data are retrieved - Step 2: Inspect the related sensor or actuator wiring for damage, corrosion, or loose connections
Wiring and connectors are in good condition - Step 3: Use a digital multimeter to check sensor voltage, resistance, and reference signals per manufacturer specifications
Values are within specified range - Step 4: Perform component-level testing of the suspected sensor or actuator
Component passes or fails definitively - Step 5: Clear codes and road test to verify repair
Code does not return and system operates normally
How to Reset
To reset code P1100: 1) Repair the underlying fault. 2) Use an OBD-II scan tool to clear the DTC. 3) Perform a drive cycle to verify the monitor completes. 4) If the code returns, further diagnosis is needed.
Frequently Asked Questions
- Q: What does OBD-II code P1100 mean?
Code P1100 indicates: KOER Test Could Not Complete. This is a Ford manufacturer-specific diagnostic trouble code.
- Q: Is code P1100 serious?
The vehicle can typically be driven but should be diagnosed soon.
- Q: Can I drive with code P1100?
You can usually drive cautiously but should have it diagnosed promptly.
- Q: How do I fix code P1100?
Diagnose the OBD Monitor system, check wiring and connectors, test the related sensor or actuator, and replace faulty components as needed.
Source: OBD-II Manufacturer Extended Codes / SAE J2012 / OBD-Codes.com
Category: OBD-II