Applicable Systems
OBD-II
Symptoms
The engine may run rough, hesitate, or have reduced power. The check engine light is on.
Possible Causes
- Faulty sensor or actuator in the affected system
- Wiring harness open or shorted
- Connector corrosion or damage
- ECM/PCM internal circuit fault
- Aftermarket modification causing interference
Troubleshooting Steps
- Step 1: Connect an OBD-II scan tool and read all stored DTCs and freeze frame data
All DTCs and freeze frame data are retrieved - Step 2: Inspect the related sensor or actuator wiring for damage, corrosion, or loose connections
Wiring and connectors are in good condition - Step 3: Use a digital multimeter to check sensor voltage, resistance, and reference signals per manufacturer specifications
Values are within specified range - Step 4: Perform component-level testing of the suspected sensor or actuator
Component passes or fails definitively - Step 5: Clear codes and road test to verify repair
Code does not return and system operates normally
How to Reset
To reset code P2195: 1) Repair the underlying fault. 2) Use an OBD-II scan tool to clear the DTC. 3) Perform a drive cycle to verify.
Frequently Asked Questions
- Q: What does OBD-II code P2195 mean?
Code P2195 indicates: EVAP System - Extended Code P2195. This is a powertrain extended diagnostic trouble code.
- Q: Is code P2195 serious?
Severity: Minor. Service as needed based on symptoms.
- Q: How do I fix code P2195?
Diagnose the EVAP System system, check wiring and connectors, and replace faulty components.
Source: OBD-II Manufacturer Extended Codes / SAE J2012 / OBD-Codes.com
Category: OBD-II