Applicable Systems
OBD-II
Symptoms
The climate control may default to defrost or stop responding. The blower may run at a fixed speed. DTC U0215 is stored by a control module that lost communication with the Climate module.
Possible Causes
- CAN bus wiring fault to climate module
- Climate module power supply fault
- Climate module internal failure
- Connector at climate module corroded
Troubleshooting Steps
- Step 1: Connect a diagnostic scanner and read all module DTCs to confirm U0215
DTC U0215 is present; note which module logged the code - Step 2: Check CAN bus wiring between the affected modules for continuity, shorts, and termination resistor values
CAN high and low lines intact, 60 ohms across the bus - Step 3: Verify power and ground supplies to the affected module
Battery voltage at module power pin, less than 0.1V drop on ground side - Step 4: If wiring is intact, the affected module may need replacement and programming
Communication restored after module replacement and programming
How to Reset
Clear the DTC after repair using a diagnostic scanner. The code will clear automatically if communication is restored and no fault is detected for 3 consecutive drive cycles.
Common Replacement Parts
- varies: Climate control module (if confirmed faulty) (Confirm part number via VIN before ordering; programming typically required)
Frequently Asked Questions
- Q: What does code U0215 mean?
This is a network communication DTC indicating lost communication with the Climate module. The CAN bus wiring, module power supply, and the module itself should be checked.
- Q: Can I drive with code U0215?
Driving may be possible but the affected system may not function. If the code relates to ECM, transmission, or brake communication, have it diagnosed promptly for safety.
Source: SAE J2012 Standard OBD-II Diagnostic Trouble Codes
Category: OBD-II