Applicable Systems
CJ/CS Series
Symptoms
The SYSMAC reports a parameter error. One or more configuration parameters contain invalid values or conflicting settings.
Possible Causes
- Parameter value entered outside the valid range
- Parameter write was interrupted before completion
- Incompatible parameter combination detected by the firmware
Troubleshooting Steps
- Step 1: Review the parameter list and identify the invalid or conflicting setting
Invalid parameter identified - Step 2: Set the parameter to a valid value within the specified range
Parameter value is now within the valid range - Step 3: Save the corrected parameters and verify the configuration is accepted
Drive accepts the configuration without error
How to Reset
To reset: Correct the parameter values, save, then cycle power and restart.
Source: Omron CJ/CS Series PLC Programming Manual, Omron Corporation
Category: PLC & VFD