Opel P1115: Opel OBD-II Error Code P1115

Symptoms

The ECM has detected a manufacturer-specific fuel system fault. The engine may have reduced power or rough idle. DTC P1115 is stored in the Opel engine control module.

Possible Causes

Fuel injector circuit fault
Fuel pump output low
Fuel pressure regulator fault
Engine coolant temperature sensor fault

Troubleshooting Steps

Step 1: Connect an OBD-II scanner and read DTCs to confirm P1115
DTC P1115 present with freeze frame data
Step 2: Inspect wiring and connectors in the affected circuit for damage, corrosion, or loose pins
Wiring intact, connectors clean and seated
Step 3: Perform component-level testing per manufacturer service manual
Component values within spec or component confirmed faulty
Step 4: Repair or replace the faulty component, clear DTC, and verify no return
DTC cleared and does not return after a road test

How to Reset

Clear the DTC after repair using a diagnostic scanner. The code clears automatically if the fault is not detected for 3 consecutive drive cycles.

Common Replacement Parts

varies: Diagnose and replace the confirmed faulty component (Confirm part number via VIN at a Opel dealership)

Frequently Asked Questions

Q: What does P1115 mean?
This manufacturer-specific DTC indicates a fuel & air metering system fault. Refer to the vehicle's service manual for the exact diagnostic procedure.
Q: Can I drive with P1115?
Limited driving is possible, but the affected system may not operate correctly. Have the vehicle diagnosed promptly to prevent potential damage.

Opel OBD-II Error Code P1115