SMA Sunny Boy Error Code 202

SMA PLC & VFD Major Grid

Model: Sunny Boy | Code: 202

Applicable Systems
Sunny Boy

Symptoms

Grid voltage measurement fault. The inverter's AC grid voltage measurement circuit has malfunctioned. Voltagereadings may be incorrect.

Possible Causes

  • Voltage measurement circuit component failure
  • Voltage sensor calibration drift
  • Measurement circuit power supply fault
  • Firmware measurement algorithm error

Troubleshooting Steps

  1. Step 1: Check the equipment status and fault indicators to confirm the active fault code
    Fault indicator or HMI displays code 202 as active
  2. Step 2: Verify all electrical connections, wiring harnesses, and connector seating
    All connections secure, no corrosion, loose pins, or damaged wires
  3. Step 3: Measure the input power supply voltage at the equipment terminals with a multimeter
    Voltage reading is within the equipment's specified operating range
  4. Step 4: Inspect the power input wiring, breakers, and fuses for damage or degradation
    Wiring intact, breakers closed, fuses continuous
  5. Step 5: Check for transient voltage events or power quality issues using a power analyzer
    No sustained overvoltage, undervoltage, or phase imbalance detected
  6. Step 6: Reset the fault after correcting the power issue: fix root cause, then press RESET or power-cycle
    Fault clears and equipment resumes normal operation

How to Reset

To reset: 1) Identify and fix the root cause described in the fault symptoms. 2) Press RESET on the HMI or controller, or power-cycle the equipment. 3) If the fault recurs, contact manufacturer service. Caution: Document the fault code and context before resetting.

Frequently Asked Questions

  • Q: What does fault code 202 mean on the SMA Sunny Boy?

    Fault 202 on the SMA Sunny Boy indicates: Grid voltage measurement fault. The inverter's AC grid voltage measurement circuit has malfunctioned. Voltage readings may be incorrect. Refer to the equipment manual and manufacturer support for specific troubleshooting steps.

  • Q: Can I continue operating the equipment with fault 202 active?

    No. The equipment has detected a fault condition and has taken protective action (typically stopping or derating). Continuing to operate without fixing the root cause may cause further damage. Always investigate and fix the fault before resuming operation.

Related SMA Fault Codes

Source: SMA Sunny Boy Inverter Installation and Operation Manual, SMA Official Documentation

Category: PLC & VFD