Applicable Systems
Steam Trap
Symptoms
The Steam Trap reports a ground fault. Leakage current to ground was detected at the drive output, indicating insulation failure.
Possible Causes
- Motor cable insulation damage causing current leakage to ground
- Motor winding insulation breakdown to the motor frame
- Water or moisture ingress in the motor junction box or cable
Troubleshooting Steps
- Step 1: Disconnect the motor cable and test motor winding insulation with a megger
Insulation resistance is above the minimum threshold - Step 2: Inspect the motor cable for physical damage or water ingress
Cable is intact and dry - Step 3: Repair or replace any cable or motor with failed insulation
Ground fault is cleared after repair
How to Reset
To reset: Fix the ground fault, then reset the fault via the keypad or cycle power.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Spirax Sarco Steam System Manual, Spirax Sarco Limited
Category: Boiler
No comments yet. Be the first to share your experience!