Applicable Systems
ZX
Symptoms
A yarn or thread break has been detected. The machine has stopped to allow rethreading.
Possible Causes
- Yarn tension excessive or inconsistent
- Yarn quality issue or weak spot
- Guide or eyelet worn or sharp-edged causing breaks
Troubleshooting Steps
- Step 1: Identify the broken yarn location and rethread
Yarn rethreaded successfully - Step 2: Check yarn tension at the breakage point
Tension within acceptable range - Step 3: Inspect yarn guides and eyelets for wear or damage
Guides smooth and undamaged
How to Reset
To reset: Clear the breakage fault after rethreading and verifying tension.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Tsudakoma Loom Manual, Tsudakoma Corporation
Category: Textile
No comments yet. Be the first to share your experience!