Universal Robots e-Series Error Code C343A51: The loaded firmware is too old to fully utilize the calibration data stored in the

Universal Robots Robot Minor System

Model: e-Series (UR3e/UR5e/UR10e/UR16e/UR20/UR30) | Code: C343A51

Applicable Systems
UR3 UR5 UR10 UR3e UR5e UR10e UR16e UR20 UR30

Symptoms

The joint works normally, but its calibration has improvements this firmware does not utilize.

Possible Causes

  • The joint works normally, but its calibration has improvements this firmware does not utilize.

Troubleshooting Steps

  1. Step 1: Update to a newer software release to get full joint performance
    Check if the issue is resolved after this step

How to Reset

Power cycle the robot controller and perform a complete reboot sequence. If the error persists, update the software to the latest version.

Related Universal Robots Fault Codes

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: Universal Robots Official Error Codes Directory (https://www.universal-robots.com/manuals/EN/PDF/Shared/ErrorCodes/ErrorCodes.pdf)

Category: Robot