Universal Robots e-Series Error Code C354A14: The Injection-Molding-Machine-Interface_FPGA does not respond

Universal Robots Robot Minor System

Model: e-Series (UR3e/UR5e/UR10e/UR16e/UR20/UR30) | Code: C354A14

Applicable Systems
UR3 UR5 UR10 UR3e UR5e UR10e UR16e UR20 UR30

Symptoms

The Injection-Molding-Machine-Interface_FPGA was rebooted but did not reach a responsive state

Possible Causes

  • The Injection-Molding-Machine-Interface_FPGA was rebooted but did not reach a responsive state

Troubleshooting Steps

  1. Step 1: Update software,
    Check if the issue is resolved after this step
  2. Step 2: Contact your local Universal Robots service provider for assistance
    Check if the issue is resolved after this step

How to Reset

Power cycle the robot controller and perform a complete reboot sequence. If the error persists, update the software to the latest version.

Related Universal Robots Fault Codes

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: Universal Robots Official Error Codes Directory (https://www.universal-robots.com/manuals/EN/PDF/Shared/ErrorCodes/ErrorCodes.pdf)

Category: Robot