Universal Robots e-Series Error Code C450A5: Force-Torque sensor is detected but not calibrated

Universal Robots Robot Minor System

Model: e-Series (UR3e/UR5e/UR10e/UR16e/UR20/UR30) | Code: C450A5

Applicable Systems
UR3 UR5 UR10 UR3e UR5e UR10e UR16e UR20 UR30

Symptoms

Force-Torque sensor is installed, but no calibration was found.

Possible Causes

  • Force-Torque sensor is installed, but no calibration was found.

Troubleshooting Steps

  1. Step 1: Conduct a complete rebooting sequence,
    Check if the issue is resolved after this step
  2. Step 2: Contact your local Universal Robots service provider for assistance
    Check if the issue is resolved after this step

How to Reset

Power cycle the robot controller and perform a complete reboot sequence. If the error persists, update the software to the latest version.

Related Universal Robots Fault Codes

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: Universal Robots Official Error Codes Directory (https://www.universal-robots.com/manuals/EN/PDF/Shared/ErrorCodes/ErrorCodes.pdf)

Category: Robot