Yasnac LX1 Alarm 51

Yasnac CNC Major Alarm

Model: LX1 | Code: 51

Applicable Systems
2000B 2000G 3000G J50 LX1/LX2/LX3 MX1/MX2/MX3

Symptoms

Alarm 51: PROG ERROR (G11 / 12). The Yasnac LX1 CNC system displays this alarm on the operator panel.

Possible Causes

  • Refer to the machine manual for detailed cause analysis
  • Check related sensors, switches, and parameters

Troubleshooting Steps

  1. Step 1: Read alarm 51 on the CNC display and note the full alarm message
    Alarm code and description displayed for diagnosis
  2. Step 2: Check the machine status and identify any obvious mechanical, electrical, or pneumatic issues
    Visible faults identified or confirmed as intermittent
  3. Step 3: Consult the manufacturer manual for alarm-specific troubleshooting procedures
    Root cause identified per manufacturer guidelines
  4. Step 4: Apply the recommended fix and reset the alarm
    Alarm cleared and machine resumed normal operation

How to Reset

To reset alarm 51: 1) Address the root cause. 2) Press the RESET key on the CNC panel. 3) If the alarm persists, cycle power to the control. Caution: Repeated alarms without fixing the cause may cause damage.

Frequently Asked Questions

  • Q: What does alarm 51 mean?

    Alarm 51 corresponds to: PROG ERROR (G11 / 12). This is a LX1 system alarm that typically requires checking machine state and the manufacturer manual.

Related Yasnac Fault Codes

Source: HelmanCNC.com - https://www.helmancnc.com/yasnac-lx1-alarm-codes/

Category: CNC