Beckhoff TwinCAT NC Error Code 0x4107

Beckhoff CNC Major Axis

Model: TwinCAT NC | Code: 0x4107

Applicable Systems
TwinCAT NC

Symptoms

NC axis not initialized. The axis has not been initialized in the TwinCAT NC system. Motion commands cannotbe executed until initialization is complete.

Possible Causes

  • Axis not started after power-on or reset
  • Axis configuration parameters invalid or incomplete
  • Drive communication not established (EtherCAT, PROFIBUS)
  • Axis enable signal not set

Troubleshooting Steps

  1. Step 1: Check the equipment status and fault indicators to confirm the active fault code
    Fault indicator or HMI displays code 0x4107 as active
  2. Step 2: Verify all electrical connections, wiring harnesses, and connector seating
    All connections secure, no corrosion, loose pins, or damaged wires
  3. Step 3: Check encoder cable and connector at both motor and drive/controller ends
    Cable intact, connector fully seated, no bent or corroded pins
  4. Step 4: Verify encoder signal integrity with an oscilloscope if available
    Signal waveform normal with clean edges, no dropouts or noise
  5. Step 5: Check for mechanical interference, coupling slippage, or excessive load on the axis
    No mechanical interference, coupling secure, load within rated capacity
  6. Step 6: Verify the axis reference point and home position are valid
    Axis has valid reference point, position data is consistent
  7. Step 7: Replace encoder if signal is consistently absent or corrupted after cable checks
    New encoder provides stable, clean signal

How to Reset

To reset: 1) Identify and fix the root cause described in the fault symptoms. 2) Press RESET on the HMI or controller, or power-cycle the equipment. 3) If the fault recurs, contact manufacturer service. Caution: Document the fault code and context before resetting.

Frequently Asked Questions

  • Q: What does fault code 0x4107 mean on the Beckhoff TwinCAT NC?

    Fault 0x4107 indicates a position or encoder-related fault. The control system has detected an issue with axis positioning, speed feedback, or encoder signal. Check the encoder cable and motor feedback system.

  • Q: Can I continue operating the equipment with fault 0x4107 active?

    No. The equipment has detected a fault condition and has taken protective action (typically stopping or derating). Continuing to operate without fixing the root cause may cause further damage. Always investigate and fix the fault before resuming operation.

Related Beckhoff Fault Codes

Source: Beckhoff TwinCAT NC Error Codes (TwinCAT2_NC_Error_Codes_EN.pdf), Beckhoff Automation

Category: CNC