Beckhoff TwinCAT NC Error Code 0x4114

Beckhoff CNC Major Parameter

Model: TwinCAT NC | Code: 0x4114

Applicable Systems
TwinCAT NC

Symptoms

NC axis parameter fault. An axis parameter value is invalid or out of range.

Possible Causes

  • Axis parameter value outside allowed range
  • Parameter combination invalid or contradictory
  • Parameter corrupted by memory fault
  • Parameter not compatible with axis type or drive configuration

Troubleshooting Steps

  1. Step 1: Check the equipment status and fault indicators to confirm the active fault code
    Fault indicator or HMI displays code 0x4114 as active
  2. Step 2: Verify all electrical connections, wiring harnesses, and connector seating
    All connections secure, no corrosion, loose pins, or damaged wires
  3. Step 3: Check the battery voltage with a multimeter at the battery holder or terminal
    Battery voltage above the minimum threshold (typically 2.7V for 3V lithium)
  4. Step 4: If battery is depleted, replace it with the manufacturer-specified battery type
    New battery installed, voltage measures nominal value
  5. Step 5: Reload the configuration or program from a known-good backup
    Configuration loads successfully and equipment enters normal state
  6. Step 6: Verify all parameters and settings are correct after reload
    All parameters match the backup or factory defaults

How to Reset

To reset: 1) Identify and fix the root cause described in the fault symptoms. 2) Press RESET on the HMI or controller, or power-cycle the equipment. 3) If the fault recurs, contact manufacturer service. Caution: Document the fault code and context before resetting.

Frequently Asked Questions

  • Q: What does fault code 0x4114 mean on the Beckhoff TwinCAT NC?

    Fault 0x4114 on the Beckhoff TwinCAT NC indicates: NC axis parameter fault. An axis parameter value is invalid or out of range. Refer to the equipment manual and manufacturer support for specific troubleshooting steps.

  • Q: Can I continue operating the equipment with fault 0x4114 active?

    No. The equipment has detected a fault condition and has taken protective action (typically stopping or derating). Continuing to operate without fixing the root cause may cause further damage. Always investigate and fix the fault before resuming operation.

Related Beckhoff Fault Codes

Source: Beckhoff TwinCAT NC Error Codes (TwinCAT2_NC_Error_Codes_EN.pdf), Beckhoff Automation

Category: CNC