Applicable Systems
PowerCommand
Symptoms
Warning - Crank sensor fault. The crankshaft position sensor is not providing a signal.
Possible Causes
- Crankshaft position sensor failure
- Sensor wiring damaged or air gap incorrect
Troubleshooting Steps
- Step 1: Check the crankshaft sensor signal
No signal from the sensor - Step 2: Inspect the sensor wiring and air gap, replace if needed
Sensor provides a clean signal
How to Reset
To reset: Replace the crank sensor, then acknowledge the warning.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Cummins Power Generation Control Manual, Cummins Inc.
Category: Generator
No comments yet. Be the first to share your experience!