Applicable Systems
DVP
AH500
AS300
C2000
MS300
Symptoms
The drive trips. The keypad displays E05, indicating an EEPROM fault. The internal EEPROM memory has failed a read or write operation, or the stored data is corrupted.
Possible Causes
- EEPROM hardware failure due to aging or electrical damage
- EEPROM write operation interrupted by power loss
- Electrostatic discharge damaged the EEPROM
- Firmware bug caused invalid EEPROM write
Troubleshooting Steps
- Step 1: Power cycle the drive to see if the fault clears on reboot
Fault may clear if the corruption was transient - Step 2: If the fault persists, attempt to reset parameters to factory defaults
Factory reset may clear corrupted EEPROM data - Step 3: Re-download all parameters from the engineering software
Parameters download successfully after factory reset - Step 4: If the fault persists after factory reset, the EEPROM hardware is damaged
Drive needs replacement or service
How to Reset
To reset: 1) Power cycle the drive. 2) Try a factory parameter reset. 3) Re-download all parameters. 4) If the fault persists, the EEPROM is permanently damaged. Contact Delta service. Caution: EEPROM failures may indicate the drive is reaching end of life.
Frequently Asked Questions
- Q: What is EEPROM and why does it matter?
EEPROM (Electrically Erasable Programmable Read-Only Memory) stores the drive's parameters and configuration. If it fails, the drive cannot read its configuration and cannot operate correctly.
- Q: Can I recover from an EEPROM fault?
If the fault is caused by data corruption, a factory reset and parameter re-download may fix it. If the EEPROM hardware itself is damaged, the drive must be replaced or serviced by Delta.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Delta MS300 Series User Manual, 2023
Category: PLC & VFD
No comments yet. Be the first to share your experience!