Doosan DX280 Excavator ECM Error Code 0100-03

Doosan Heavy Equipment Critical Engine

Model: DX280 Excavator ECM | Code: 0100-03

Applicable Systems
DX280 Excavator PUMA MX Series PUMA TT Series

Symptoms

The ECM detects the oil pressure sensor signal voltage is above 4.8V, indicating a short to battery positive. Engine power may be reduced and speed may decrease.

Possible Causes

  • Sensor signal wire shorted to battery positive or ground
  • Sensor internal failure producing out-of-range voltage
  • ECM connector corrosion causing cross-circuit between pins
  • Wiring harness chafing exposing conductor to power or ground

Troubleshooting Steps

  1. Step 1: Read active fault codes on the monitor panel or using ET (Electronic Technician)
    Fault code displayed as active with engine status
  2. Step 2: Disconnect the relevant sensor connector and measure signal pin voltage
    Voltage should be 0V with sensor disconnected; if battery voltage present, wiring is shorted
  3. Step 3: Inspect wiring harness from sensor to ECM for chafing or insulation damage
    No exposed conductors or insulation damage found
  4. Step 4: Replace the sensor if wiring checks good but fault persists after reconnection
    Fault clears after sensor replacement and key cycle

How to Reset

To reset: 1) Repair the short circuit or replace the faulty sensor. 2) Turn key OFF then ON. 3) Verify fault is no longer active. Caution: The ECM will use default values (600kPa for pressure, 90C for temperature) when sensor data is invalid, which may mask the real problem.

Frequently Asked Questions

  • Q: What does Doosan ECM fault code 0100-03 mean?

    Oil Pressure Sensor Short to Battery Positive. The ECM detects the oil pressure sensor signal voltage is above 4.8V, indicating a short to battery positive. Engine power may be reduced and speed may decrease.

  • Q: What default values does the ECM use when sensor data is invalid?

    The ECM uses 600kPa as default for fuel and oil pressure sensors, and 90 degrees C as default for coolant temperature. These defaults may not reflect actual conditions.

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: Doosan DX280 Excavator ECM Manual; 21-sun.com (China Construction Machinery Commerce Network); cehome.com; sohu.com

Category: Heavy Equipment