Applicable Systems
TransSteel 2700
Symptoms
The welding system reports a robot communication timeout. The data link with the welding robot controller has timed out.
Possible Causes
- Communication cable disconnected or damaged
- Robot controller communication module fault
- Protocol mismatch or addressing error
Troubleshooting Steps
- Step 1: Check the communication cable connections
Connections are secure at both ends - Step 2: Verify the robot controller communication status
Module shows normal operation - Step 3: Check communication parameters and address
Settings match the configuration
How to Reset
To reset: Restore the communication link, then reset the interface.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Fronius Welding System Manual, Fronius International GmbH
Category: Welding
No comments yet. Be the first to share your experience!