Applicable Systems
TransSteel 2700
Symptoms
The welding system reports a workpiece detection anomaly. The workpiece presence detection is not functioning.
Possible Causes
- Workpiece sensor contaminated or worn
- Sensor wiring or connector fault
- Sensor calibration incorrect
Troubleshooting Steps
- Step 1: Inspect and clean the workpiece sensor
Sensor is clean and unobstructed - Step 2: Check sensor wiring and connections
Wiring is intact and connections are secure - Step 3: Verify sensor calibration against a reference
Sensor detects the workpiece reliably
How to Reset
To reset: Repair the workpiece sensor, then clear the fault.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Fronius Welding System Manual, Fronius International GmbH
Category: Welding
No comments yet. Be the first to share your experience!