Applicable Systems
TransSteel 2700
Symptoms
The welding system reports a wire jam. The welding wire is jammed in the feed system.
Possible Causes
- Wire tangle in the spool or feed tube
- Drive roller groove worn or wrong size
- Liner clogged with debris or wire shavings
Troubleshooting Steps
- Step 1: Inspect the wire spool for tangles
Wire feeds smoothly from the spool - Step 2: Verify the drive roller matches the wire size
Roller grips wire without slipping - Step 3: Clean or replace the welding liner
Wire feeds freely through the liner
How to Reset
To reset: Clear the wire jam, then clear the fault.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Fronius Welding System Manual, Fronius International GmbH
Category: Welding
No comments yet. Be the first to share your experience!