Applicable Systems
TransSteel 2700
Symptoms
The system calibration is out of specification.
Possible Causes
- The system calibration is out of specification.
Troubleshooting Steps
- Step 1: Recalibrate the system according to the manual
Check if the issue is resolved - Step 2: If the error persists, contact Fronius service.
Check if the issue is resolved
How to Reset
Power cycle the welding system and wait for the self-test to complete. If the error persists, contact Fronius service.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Fronius welding technology documentation and xueke.org troubleshooting guide
Category: Welding
No comments yet. Be the first to share your experience!