Applicable Systems
Fujitec Control System
Symptoms
Actual acceleration does not match command acceleration
Possible Causes
- Encoder or wiring fault
- IF61 board fault
- inverter fault or setting error
- load too heavy
Troubleshooting Steps
- Step 1: Check encoder
Verify the fault is resolved after completing this step. - Step 2: verify wiring
Verify the fault is resolved after completing this step. - Step 3: inspect IF61
Verify the fault is resolved after completing this step. - Step 4: check inverter settings
Verify the fault is resolved after completing this step. - Step 5: verify load conditions
Verify the fault is resolved after completing this step.
How to Reset
Power cycle after adjustment
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: baijiahao (huasheng fujitec); toutiao.com/w/1874164112328836
Category: Elevator
No comments yet. Be the first to share your experience!