Applicable Systems
GX
Symptoms
Temperature has exceeded the safe operating limit. The system has tripped to prevent thermal damage to components.
Possible Causes
- Cooling system performance degraded or flow restricted
- Excessive heat load beyond system capacity
- Temperature sensor calibration drift or failure
Troubleshooting Steps
- Step 1: Verify actual temperature with an independent measurement
Temperature confirmed above trip point - Step 2: Inspect cooling system components for proper operation
Cooling system fault identified and corrected - Step 3: Check temperature sensor calibration and wiring continuity
Sensor reading verified accurate
How to Reset
To reset: Clear the temperature alarm after confirming the cooling system is functioning properly.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: KraussMaffei Injection Molding Manual, KraussMaffei Group
Category: Injection Molding
No comments yet. Be the first to share your experience!