SMA Sunny Boy Error Code 1101

SMA PLC & VFD Major System

Model: Sunny Boy | Code: 1101

Applicable Systems
Sunny Boy

Symptoms

Installation fault. The inverter has detected an installation configuration that does not meet requirements.

Possible Causes

  • Incorrect AC cable cross-section for the rated current
  • DC switch in OFF position while attempting to start
  • Inverter installed in prohibited location (e.g., direct sun, no ventilation)
  • Configuration parameters not matching installed hardware

Troubleshooting Steps

  1. Step 1: Check the equipment status and fault indicators to confirm the active fault code
    Fault indicator or HMI displays code 1101 as active
  2. Step 2: Verify all electrical connections, wiring harnesses, and connector seating
    All connections secure, no corrosion, loose pins, or damaged wires
  3. Step 3: Check the system diagnostic buffer or event log for detailed fault information
    Diagnostic buffer shows the specific fault cause and timestamp
  4. Step 4: Verify power supply stability and environmental conditions
    Power supply stable, environment within specifications
  5. Step 5: Restart the equipment or power-cycle the control system
    Equipment restarts and enters normal operating state
  6. Step 6: Contact manufacturer support if the fault persists after all checks
    Support provides specific troubleshooting guidance

How to Reset

To reset: 1) Identify and fix the root cause described in the fault symptoms. 2) Press RESET on the HMI or controller, or power-cycle the equipment. 3) If the fault recurs, contact manufacturer service. Caution: Document the fault code and context before resetting.

Frequently Asked Questions

  • Q: What does fault code 1101 mean on the SMA Sunny Boy?

    Fault 1101 on the SMA Sunny Boy indicates: Installation fault. The inverter has detected an installation configuration that does not meet requirements. Refer to the equipment manual and manufacturer support for specific troubleshooting steps.

  • Q: Can I continue operating the equipment with fault 1101 active?

    No. The equipment has detected a fault condition and has taken protective action (typically stopping or derating). Continuing to operate without fixing the root cause may cause further damage. Always investigate and fix the fault before resuming operation.

Related SMA Fault Codes

Source: SMA Sunny Boy Inverter Installation and Operation Manual, SMA Official Documentation

Category: PLC & VFD