Applicable Systems
ThyssenKrupp Control System
Symptoms
MP (main processor) board fault detected - code 0C 08
Possible Causes
- MP board hardware failure
- firmware corruption
- watchdog timeout
Troubleshooting Steps
- Step 1: Check MP board power supply
Verify the fault is resolved after completing this step. - Step 2: re-flash firmware
Verify the fault is resolved after completing this step. - Step 3: replace MP board if faulty
Verify the fault is resolved after completing this step.
How to Reset
Power cycle; replace MP board if persistent
Source: beijiaxin.cn; zhihu.com/p/577262471; renrendoc MC2-C manual
Category: Elevator