Applicable Systems
RTAC 200
Symptoms
Emergency stop interface fault. The emergency stop circuit is not functioning correctly.
Possible Causes
- Emergency stop button stuck or wiring broken
- Emergency stop relay failure
Troubleshooting Steps
- Step 1: Check the emergency stop circuit continuity
Circuit is open due to stuck button or broken wire - Step 2: Repair or replace the faulty component
Circuit is complete after repair
How to Reset
To reset: Fix the emergency stop circuit, then reset the controller.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Trane HVAC Service Manual, Trane Inc.
Category: HVAC Residential
No comments yet. Be the first to share your experience!