Applicable Systems
UR3
UR5
UR10
UR3e
UR5e
UR10e
UR16e
UR20
UR30
Symptoms
The M8 digital output sinking current exceeded the allowed single pin limit.
Possible Causes
- The M8 digital output sinking current exceeded the allowed single pin limit.
Troubleshooting Steps
- Step 1: Make sure you are not sinking too much current into the digital output pin,
Check if the issue is resolved after this step - Step 2: Update software,
Check if the issue is resolved after this step - Step 3: Contact your local Universal Robots service provider for assistance
Check if the issue is resolved after this step
How to Reset
Power cycle the robot controller and perform a complete reboot sequence. If the error persists, update the software to the latest version.
Comments (0)
Share your experience to help others facing the same problem.
Leave a Comment
Source: Universal Robots Official Error Codes Directory (https://www.universal-robots.com/manuals/EN/PDF/Shared/ErrorCodes/ErrorCodes.pdf)
Category: Robot
No comments yet. Be the first to share your experience!