Universal Robots e-Series Error Code C353A5: Timeout occurred while configuring IMU A

Universal Robots Robot Minor System

Model: e-Series (UR3e/UR5e/UR10e/UR16e/UR20/UR30) | Code: C353A5

Applicable Systems
UR3 UR5 UR10 UR3e UR5e UR10e UR16e UR20 UR30

Symptoms

A timeout occured while configuring inertial measurement unit A

Possible Causes

  • A timeout occured while configuring inertial measurement unit A

Troubleshooting Steps

  1. Step 1: Conduct a complete rebooting sequence,
    Check if the issue is resolved after this step
  2. Step 2: Update software,
    Check if the issue is resolved after this step
  3. Step 3: Contact your local Universal Robots service provider for assistance,
    Check if the issue is resolved after this step
  4. Step 4: Replace the BFB PCB
    Check if the issue is resolved after this step

How to Reset

Power cycle the robot controller and perform a complete reboot sequence. If the error persists, update the software to the latest version.

Related Universal Robots Fault Codes

Comments (0)

Share your experience to help others facing the same problem.

No comments yet. Be the first to share your experience!

Leave a Comment

Source: Universal Robots Official Error Codes Directory (https://www.universal-robots.com/manuals/EN/PDF/Shared/ErrorCodes/ErrorCodes.pdf)

Category: Robot